Water under a sink or vanity
Moisture around cabinet bases, traps, supply lines, or shutoffs should be traced before it reaches flooring, drywall, or surrounding finishes.
Plumbing Services in Seattle, WA
Repairs, replacements, fixtures, leak detection, water lines, shutoffs, and drains—done cleanly, tested carefully, and scheduled promptly.
Prefer to call? (360) 812-5445
What we fix & install
From a dripping faucet to new shutoffs and clean drain work, we handle the visible, serviceable plumbing details that keep your home running.
Planning a full bathroom? See Bathroom Remodeling →- Leak detection & repair — trace, isolate, and correct supply or drain leaks.
- Fixtures — faucets, sinks, shower valves, toilets, disposals, and cartridges.
- Water lines & shutoffs — replacements, angle stops, and main shutoff upgrades.
- Drains & traps — clogs, trap replacements, and venting checks.
- Toilet, tub & shower hookups — flanges, wax rings, supply lines, and overflow checks.
- Appliance hookups — dishwashers and refrigerator lines where applicable.
- Code & safety — gaskets, sealants, dielectric unions, and GFCI coordination.
- Bathroom integration — seamless tie-ins with tile and vanity work.
When to call for plumbing help
Small plumbing symptoms can point to worn parts, poor sealing, aging supply lines, or drain issues. We start by confirming the source, then explain whether a repair, replacement, or coordinated remodel scope makes the most sense.
Dripping faucets or running toilets
Worn cartridges, seals, flappers, and fill valves can waste water and often point to parts that are ready for service.
Slow drains or loose connections
We check the trap, tailpiece, fittings, visible venting conditions, and seals instead of treating every slow drain as the same problem.
Old shutoffs that do not close
Stuck or leaking angle stops make future fixture work harder. Replacing them improves serviceability before a larger repair is needed.
Diagnostic & repair process
- 1
Inspect & Isolate
Identify symptoms, protect finishes, and isolate the source of the issue.
- 2
Explain Options
Plain-English findings with pros, cons, and the estimate before work begins.
- 3
Repair or Replace
Use quality parts, precise workmanship, and proper sealing techniques.
- 4
Test & Verify
Pressure and function checks plus clean-up of the work area.
- 5
Follow-Up
Care tips and what to monitor after the repair.
Parts, connections, and access we review
Good plumbing work is not only the visible fixture. During the estimate and repair, we look at the surrounding parts that affect reliability, serviceability, and clean installation.
When plumbing is part of a wider tile, flooring, vanity, or ADU scope, we coordinate it with the surrounding finish work. See Additional Services →
- Fixture compatibility with existing rough-ins and local code requirements
- Shutoff valve condition, braided supply lines, cartridges, traps, and gaskets
- Drain pitch, trap alignment, overflow connections, and visible venting concerns
- Where access is available without unnecessary damage to finished surfaces
- Coordination points when plumbing work is part of tile, vanity, or bathroom remodeling
Preventive upgrades
Small upgrades can prevent big headaches. Ask about water-saving fixtures, fresh shutoffs, and supply line updates.
- New angle stops & braided supplies
- Quiet, efficient WaterSense fixtures
- Proper trap arms and venting
- Dielectric unions on dissimilar metals
- Accessible cleanouts
Example plumbing work in Seattle
Seattle, WA
Bathroom Plumbing & Shower Prep
Open-wall plumbing access and shower finish work documented during a bathroom remodel.
- Plumbing access
- Shower fixtures
Plumbing FAQs
Can you fix a leak without opening the wall?
It depends on the source and access. We start with non-invasive diagnostics and review options if opening is required.
Do you replace shutoff valves and supply lines?
Yes. Fresh shutoffs and braided supplies improve safety and serviceability.
Do you handle clogs and slow drains?
Yes. We address localized blockages, check traps and vents, and re-seal connections as needed.
Can you install new fixtures we purchased?
In most cases, yes—provided the fixtures are compatible and meet local code. We confirm during the estimate.
Do you work inside full bathroom remodels?
Yes. Plumbing scopes integrate with our remodeling work for seamless coordination.
Are you licensed and insured?
Yes—licensed, insured, and backed by workmanship warranty information in your estimate.
Service area
Seattle, Everett, Bellevue, Kirkland, Redmond, Bothell, Lynnwood, Shoreline, and Edmonds. If you are nearby, call to confirm availability.
Seattle, WA
Everett, WA
Bellevue, WA
Kirkland, WA
Redmond, WA
Bothell, WA
Lynnwood, WA
Shoreline, WA
Edmonds, WA
Tell us what plumbing help you need
Call for immediate help or fill out the form below to describe your plumbing needs.